Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
FarmerTec Huztl MS660 Updated Build Kit - Build Thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Schmalts" data-source="post: 6633423" data-attributes="member: 157930"><p>Well I took one of the 2 clutch side bearings apart to find why the farmertec bearing feels like crap. My bad, in my post yesterday I said it was the flywheel side, i was not at my saw when I posted it, but the gritty bearings are the clutch side. Here is what I found.... I rolled one ball in the race until I found the tick, and then inspected it. Not good, my advise is to roll your kit bearings very fast on your finger, and load and turn them as well to see if you feel any clicking spots. Look what I found, those bearing would have spalled in short time. Farmertec needs to get this fixed, Do not install these![ATTACH=full]666127[/ATTACH]</p><p> Again, anyone have an AM source for these that are worth a crap</p></blockquote><p></p>
[QUOTE="Schmalts, post: 6633423, member: 157930"] Well I took one of the 2 clutch side bearings apart to find why the farmertec bearing feels like crap. My bad, in my post yesterday I said it was the flywheel side, i was not at my saw when I posted it, but the gritty bearings are the clutch side. Here is what I found.... I rolled one ball in the race until I found the tick, and then inspected it. Not good, my advise is to roll your kit bearings very fast on your finger, and load and turn them as well to see if you feel any clicking spots. Look what I found, those bearing would have spalled in short time. Farmertec needs to get this fixed, Do not install these![ATTACH=full]666127[/ATTACH] Again, anyone have an AM source for these that are worth a crap [/QUOTE]
Insert quotes…
Verification
Post reply
Top