Want to Buy Husqvarna 266SE P/C

[Cliff R]

Looking for a good P/C for a Husqvarna 266SE.

PM or email to: [email protected]

thanks.....

 

[Brandon Bondeson]

what is a p/c?

 

[bigbadbob]

Piston/cylinder

 

[Brandon Bondeson]

oh ok thanks and that is about the only 266se parts I don't have

 

[chainsawman2011]

I believe I have one will try to check after work tomorrow


Sent from my iPhone using Tapatalk

 

[Johny.W]

I think I have sum will check

 

[Brandon Bondeson]

i have a cylinder with low compression you could hone it out and use a big bore piston/ring pm if interested it will run i had it on my 266se but it was only pushing 125-130 psi

 

[Johny.W]

you cant bore a saw cylinder its got plating

 

[Johny.W]

I have this P/C its a bit ruff

 

[Brandon Bondeson]

you cant bore a saw cylinder its got plating

i know a few people who have done even though it may not be the correct thing to do however i do still have that p/c if your interested it does not have a ring but it is in much better condition than the one shown above