Husqvarna 395xp crank seals

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

JakeHobbs

New Member
Joined
Oct 29, 2018
Messages
1
Reaction score
0
Location
Missouri
I am just finishing a rebuild on a 395xp and have some concerns about the flywheel side crank seal. I haven't been able to locate a service manual for the 395, but have a manual for the 394. It says to recess the seal 5mm from the outer machined edge of the case. This seems rather deep. Does anyone have any good info on this, or better yet pictures of a properly installed seal.
 
I am just finishing a rebuild on a 395xp and have some concerns about the flywheel side crank seal. I haven't been able to locate a service manual for the 395, but have a manual for the 394. It says to recess the seal 5mm from the outer machined edge of the case. This seems rather deep. Does anyone have any good info on this, or better yet pictures of a properly installed seal.
husky saws often require countersinking the seal depths to prevent the flywheel
from digging into the seal .My 181se lists 3.5 mil below pocket
 

Latest posts

Back
Top