Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
I need your advice on this Husky cylinder.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="timberwolf" data-source="post: 1405903" data-attributes="member: 2784"><p>That does not look bad. Maybe just a little 400 or 600 grit wet paper on the finger tip will finish the job. I would think it would be fine run just as shown.</p><p></p><p>You can protect areas you don't want etched with candle wax while you apply acid.</p></blockquote><p></p>
[QUOTE="timberwolf, post: 1405903, member: 2784"] That does not look bad. Maybe just a little 400 or 600 grit wet paper on the finger tip will finish the job. I would think it would be fine run just as shown. You can protect areas you don't want etched with candle wax while you apply acid. [/QUOTE]
Insert quotes…
Verification
Post reply
Top