Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Low compression, husky 346xp
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="ForesterDan" data-source="post: 6524903" data-attributes="member: 155858"><p>Hi all, </p><p></p><p>I'm looking for help with a Husqvarna 346xp rebuild. I replaced the rubber boot in the manifold (which was broken), the gasket and the cylinder and piston (both scored). After all that I did a pressure test with no leaks so I went ahead and put her back together. Then came the compression test and she only scored a meager 100psi.</p><p></p><p>Would anyone have a suggestion as to where to go from here?</p></blockquote><p></p>
[QUOTE="ForesterDan, post: 6524903, member: 155858"] Hi all, I'm looking for help with a Husqvarna 346xp rebuild. I replaced the rubber boot in the manifold (which was broken), the gasket and the cylinder and piston (both scored). After all that I did a pressure test with no leaks so I went ahead and put her back together. Then came the compression test and she only scored a meager 100psi. Would anyone have a suggestion as to where to go from here? [/QUOTE]
Insert quotes…
Verification
Post reply
Top