Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
MS660 stall/stumble when stopped in cut
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="smokey7" data-source="post: 6214848" data-attributes="member: 124945"><p>I'd be curious to see if it was all better if you went to 13600 13800. I know it sounds line its high rams but if its properly tuned there i would run it. Think about it saws never run no load in the cut. So max wot really don't matter. Tune it till its right and cut wood. I know it sounds harsh but proper is proper</p></blockquote><p></p>
[QUOTE="smokey7, post: 6214848, member: 124945"] I'd be curious to see if it was all better if you went to 13600 13800. I know it sounds line its high rams but if its properly tuned there i would run it. Think about it saws never run no load in the cut. So max wot really don't matter. Tune it till its right and cut wood. I know it sounds harsh but proper is proper [/QUOTE]
Insert quotes…
Verification
Post reply
Top