Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Need help with a muff mod! Can't get a Husqvarna muffler uncrimped.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="shorthunter" data-source="post: 5287163" data-attributes="member: 116935"><p>I am not familiar with the 125 but you may consider a fish gill opening. Simply cut a portion of the muffler and open it up with a screwdriver. I use a die grinder with a cutoff wheel to cut my opening, then pry it open with a flathead screwdriver. The best thing about this style of opening is that you can fine tune the backpressure by closing the fish gill back down a bit or by opening it up a little more</p></blockquote><p></p>
[QUOTE="shorthunter, post: 5287163, member: 116935"] I am not familiar with the 125 but you may consider a fish gill opening. Simply cut a portion of the muffler and open it up with a screwdriver. I use a die grinder with a cutoff wheel to cut my opening, then pry it open with a flathead screwdriver. The best thing about this style of opening is that you can fine tune the backpressure by closing the fish gill back down a bit or by opening it up a little more [/QUOTE]
Insert quotes…
Verification
Post reply
Top