Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
NWP shortblock ms 390 shearing flywheel key
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="HuskStihl" data-source="post: 4596725" data-attributes="member: 85012"><p>Before I learned on here that you don't need a key, I sheared one, used a triangular file to make a groove in the flywheel where the old key was, made a new "key", glued it into the groove and reassembled. Prolly just needed to torque it back down</p></blockquote><p></p>
[QUOTE="HuskStihl, post: 4596725, member: 85012"] Before I learned on here that you don't need a key, I sheared one, used a triangular file to make a groove in the flywheel where the old key was, made a new "key", glued it into the groove and reassembled. Prolly just needed to torque it back down [/QUOTE]
Insert quotes…
Verification
Post reply
Top