Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Oil or Carbon Staining on Side of Piston on Newish Saw
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Firemech86" data-source="post: 6109822" data-attributes="member: 147867"><p>I had my muffler off of my 261cm this morning, had the same varnish on the piston but not as bad. I have only run the Husqvarna premix in this saw (I can get it locally much cheaper than the motomix or VP ethanol free stuff), I am not going to worry about it. I can't use pump gas here, the 3 stations I have checked all have 20+% alcohol in the fuel. Cost me a saw already. </p><p></p><p>Sent from my SM-G930V using Tapatalk</p></blockquote><p></p>
[QUOTE="Firemech86, post: 6109822, member: 147867"] I had my muffler off of my 261cm this morning, had the same varnish on the piston but not as bad. I have only run the Husqvarna premix in this saw (I can get it locally much cheaper than the motomix or VP ethanol free stuff), I am not going to worry about it. I can't use pump gas here, the 3 stations I have checked all have 20+% alcohol in the fuel. Cost me a saw already. Sent from my SM-G930V using Tapatalk [/QUOTE]
Insert quotes…
Verification
Post reply
Top