Finishing up some piping on my OWB CB5036 install...planned on water thermometers all over the place to monitor stuff...usually get this type stuff from my favorite industrial supply house McMaster Carr but they were 40-50 bucks each there...has to be a better source...what did you guys use? How much $$$ roughly? I assume they just thread into a block with a pex fitting on each end or threaded end that you put a pex fitting on each end?
OWB installs...water thermometer source?
- Thread starter Slick
- Start date
Help Support Arborist Forum:
ericjeeper
Addicted to ArboristSite
On one of the "wells" On my home made boiler
I used a simple mechanical auto water temp gauge, goes from 130-230 I think.. No moving or electrical parts. I think it was about 20 bucks from NAPA
I used a simple mechanical auto water temp gauge, goes from 130-230 I think.. No moving or electrical parts. I think it was about 20 bucks from NAPA
mtfallsmikey
Addicted to ArboristSite
Thermometers from my CB dealer---$15/each.
Similar threads
