Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Chainsaw Stickies
Pioneer chainsaws
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="artie__bc" data-source="post: 1863226" data-attributes="member: 11576"><p>Oregon Tech support is wrong. The D007 mount is for the larger P series, which had 3/8" bar studs, as opposed to the 5/16" on the p25. You could use the D007 on the smaller saws, but you need the spacer, kind of an S shaped clip that fits over the studs to make them equivalent to 3/8". It's easy to modify D009 large Husky mount bars to D007 specs. You just need to file a wee bit out of the bar slot to fit the 3/8" studs. The oil & adjuster holes usually, but not always line up perfectly.</p></blockquote><p></p>
[QUOTE="artie__bc, post: 1863226, member: 11576"] Oregon Tech support is wrong. The D007 mount is for the larger P series, which had 3/8" bar studs, as opposed to the 5/16" on the p25. You could use the D007 on the smaller saws, but you need the spacer, kind of an S shaped clip that fits over the studs to make them equivalent to 3/8". It's easy to modify D009 large Husky mount bars to D007 specs. You just need to file a wee bit out of the bar slot to fit the 3/8" studs. The oil & adjuster holes usually, but not always line up perfectly. [/QUOTE]
Insert quotes…
Verification
Post reply
Top