Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Poulan Micro xxv crankshaft play
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Rob22" data-source="post: 7447978" data-attributes="member: 176357"><p>Thanks for the reply and advice. I ended up splitting the case and replacing bearings.</p><p></p><p>I've run into a problem though and could use advice. I just reassembled the halves and now the crankshaft is really tight. It takes a lot of force pushing on the balancer to get it to rotate. I can't rotate it at all if i grasp the crankshaft, whereas before I could spin it easily. Should it be this tight?[ATTACH=full]881302[/ATTACH][ATTACH=full]881303[/ATTACH][ATTACH=full]881304[/ATTACH]</p></blockquote><p></p>
[QUOTE="Rob22, post: 7447978, member: 176357"] Thanks for the reply and advice. I ended up splitting the case and replacing bearings. I've run into a problem though and could use advice. I just reassembled the halves and now the crankshaft is really tight. It takes a lot of force pushing on the balancer to get it to rotate. I can't rotate it at all if i grasp the crankshaft, whereas before I could spin it easily. Should it be this tight?[ATTACH type="full"]881302[/ATTACH][ATTACH type="full"]881303[/ATTACH][ATTACH type="full"]881304[/ATTACH] [/QUOTE]
Insert quotes…
Verification
Post reply
Top