Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Chainsaw Stickies
Remington Chainsaws(including Mall chainsaws)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Jeff Lary" data-source="post: 3538850" data-attributes="member: 75915"><p><strong>SUPER 75 Oil Plunger question</strong></p><p></p><p>[ATTACH]228423[/ATTACH][ATTACH]228424[/ATTACH]Is the plunger supposed to be bent like this? It will not move so I took the side cover off and opened the oil tank up. I wanted to see if there was an internal issue and there was none i could see. But when i took the plunger out to see if I could soak it to free it up it looked bent to me? When it is on the saw it is leaning back toward the operator some,I figured it was supposed to be for ease of use but it also seems to be bent a little.I took 1 photo then rolled it around about 180 degrees and took 1 mor photo, in that one I think you can see a little bend or sweep.Is this "sweep why it will not move</p></blockquote><p></p>
[QUOTE="Jeff Lary, post: 3538850, member: 75915"] [b]SUPER 75 Oil Plunger question[/b] [ATTACH=CONFIG]228423[/ATTACH][ATTACH=CONFIG]228424[/ATTACH]Is the plunger supposed to be bent like this? It will not move so I took the side cover off and opened the oil tank up. I wanted to see if there was an internal issue and there was none i could see. But when i took the plunger out to see if I could soak it to free it up it looked bent to me? When it is on the saw it is leaning back toward the operator some,I figured it was supposed to be for ease of use but it also seems to be bent a little.I took 1 photo then rolled it around about 180 degrees and took 1 mor photo, in that one I think you can see a little bend or sweep.Is this "sweep why it will not move [/QUOTE]
Insert quotes…
Verification
Post reply
Top