Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Chainsaw Stickies
Remington Chainsaws(including Mall chainsaws)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Steve NW WI" data-source="post: 3772135" data-attributes="member: 32687"><p>Yeah! If everyone had one, it wouldn't be so hard to find a good drive sprocket for it. Mine's pretty toasted, but will be good enough for occasional GTG use if need be.</p><p></p><p>Results of the carb rebuild are inconclusive tonight. I need to stop at the auto parts store and get some 1/4" fuel line tomorrow. The one on the saw is toast. Maybe I'll be able to find 1/4" Tygon, dunno.</p><p></p><p>I do like the "upside down" carb mounting. It's nice to put a gasket kit in without pulling the carb. I was ready to swear loudly trying to get those carb nuts off without tearing down the saw, but it looked pretty clean inside when I pulled the carb apart, so I let sleeping dogs lie. Maybe it'll bite me tomorrow, and I'll be back to square 1, we shall see.</p></blockquote><p></p>
[QUOTE="Steve NW WI, post: 3772135, member: 32687"] Yeah! If everyone had one, it wouldn't be so hard to find a good drive sprocket for it. Mine's pretty toasted, but will be good enough for occasional GTG use if need be. Results of the carb rebuild are inconclusive tonight. I need to stop at the auto parts store and get some 1/4" fuel line tomorrow. The one on the saw is toast. Maybe I'll be able to find 1/4" Tygon, dunno. I do like the "upside down" carb mounting. It's nice to put a gasket kit in without pulling the carb. I was ready to swear loudly trying to get those carb nuts off without tearing down the saw, but it looked pretty clean inside when I pulled the carb apart, so I let sleeping dogs lie. Maybe it'll bite me tomorrow, and I'll be back to square 1, we shall see. [/QUOTE]
Insert quotes…
Verification
Post reply
Top