Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Removing stuck cylinder on Jonsered 2051
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="hkusp9" data-source="post: 3885339" data-attributes="member: 83351"><p>I had this exact same question about a month ago. All the same suggestions were offered and they were good suggestions.</p><p></p><p>What i actually did was attach an impact wrench to the flywheel or clutch and give it a few seconds with the impact wrench banging on the piston to get it unstuck and unfrozen from the bad spot between the piston and cylinder, i was then able to pull off the cylinder by hand.</p></blockquote><p></p>
[QUOTE="hkusp9, post: 3885339, member: 83351"] I had this exact same question about a month ago. All the same suggestions were offered and they were good suggestions. What i actually did was attach an impact wrench to the flywheel or clutch and give it a few seconds with the impact wrench banging on the piston to get it unstuck and unfrozen from the bad spot between the piston and cylinder, i was then able to pull off the cylinder by hand. [/QUOTE]
Insert quotes…
Verification
Post reply
Top