Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Replace Carb Check Valve on CS-590?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="SteveSr" data-source="post: 7827491" data-attributes="member: 3373"><p>This is not likely to work as the main flow (75%) goes through the hole in the main jet and only 25% or so goes through the adjustable needle.</p><p></p><p>The only way to fix this is to use the correct part. The nozzle should be pulled from the metering side to allow a sealing surface for the new nozzle. If you push it through you may make a leak. Also be sure to remove the "H" screw before removing the nozzle.</p></blockquote><p></p>
[QUOTE="SteveSr, post: 7827491, member: 3373"] This is not likely to work as the main flow (75%) goes through the hole in the main jet and only 25% or so goes through the adjustable needle. The only way to fix this is to use the correct part. The nozzle should be pulled from the metering side to allow a sealing surface for the new nozzle. If you push it through you may make a leak. Also be sure to remove the "H" screw before removing the nozzle. [/QUOTE]
Insert quotes…
Verification
Post reply
Top