Stihl Bar ID

[wildwes]

I picked up a 36" Stihl bar today with the numbers mostly obscured by rust, and I was wondering if anyone can tell me what pitch and gauge it is.
The part number is 3003 000 9753. I can find a 3002 000 9753 listed online, which is a .063 .404 bar if I'm not mistaken, but I can't find a 3003 listing for it. Would I be correct in assuming it is a .404 bar for a 3003 mount?
It has a good bit of light surface rust, but the rails look good with no noticeable wear, no burrs, the tip spins free. Overall it is a pretty good bar, and it was only $20, so I want to figure out what exactly I have.

 

[Bob Hedgecutter]

According to my own stash of information booklets- 36" 3003 mount 0.063 gauge and .404 pitch requiring a chain of 108 drive links.

 

[wildwes]

Thanks! That's exactly the information I was looking for!

 

[Jimbo209]

I picked up a 36" Stihl bar today with the numbers mostly obscured by rust, and I was wondering if anyone can tell me what pitch and gauge it is.
The part number is 3003 000 9753. I can find a 3002 000 9753 listed online, which is a .063 .404 bar if I'm not mistaken, but I can't find a 3003 listing for it. Would I be correct in assuming it is a .404 bar for a 3003 mount?
It has a good bit of light surface rust, but the rails look good with no noticeable wear, no burrs, the tip spins free. Overall it is a pretty good bar, and it was only $20, so I want to figure out what exactly I have.

Check on a normal bar you have a chain for.
I Cut mine at 6DL over the tail for going around the sprocket on a 3/8 bar.
The .325 milling chain is slightly different but that's a 9 tooth drive too, which can make a difference