Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Tree Care Forums
Firewood, Heating and Wood Burning Equipment
SuperSplit flywheel set screw keeps coming loose
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="homemade" data-source="post: 7691036" data-attributes="member: 57572"><p>If you have the clearance, we always drill the shaft for set screws to set into. This is on 1.5”-3” shafts for bearings and any this else on a shaft in my gravel crusher line if work. Sometimes you can drill with a bit and not hit the threads, sometimes you gotta mark it with a pilot drill (small drill bit) then slide the flywheel off and drill a bigger dimple. You only need to go in the depth of the taper at the end of the set screw. </p><p></p><p></p><p>Sent from my iPhone using Tapatalk</p></blockquote><p></p>
[QUOTE="homemade, post: 7691036, member: 57572"] If you have the clearance, we always drill the shaft for set screws to set into. This is on 1.5”-3” shafts for bearings and any this else on a shaft in my gravel crusher line if work. Sometimes you can drill with a bit and not hit the threads, sometimes you gotta mark it with a pilot drill (small drill bit) then slide the flywheel off and drill a bigger dimple. You only need to go in the depth of the taper at the end of the set screw. Sent from my iPhone using Tapatalk [/QUOTE]
Insert quotes…
Verification
Post reply
Top