Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Tree Care Forums
Milling & Saw Mills
Two dead mills!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="albert" data-source="post: 2772625" data-attributes="member: 21406"><p>I would use 40:1 mix with a good oil and a good, fresh premium fuel for milling. Make sure you set your saw rich on the H side. 10,500 rpm would be a good starting point for the 2100 saws. Shame about your saws. I think you would be best served with Stihl ultra on husqvarna low smoke in the oil departrment. You could probally get yours going again.</p></blockquote><p></p>
[QUOTE="albert, post: 2772625, member: 21406"] I would use 40:1 mix with a good oil and a good, fresh premium fuel for milling. Make sure you set your saw rich on the H side. 10,500 rpm would be a good starting point for the 2100 saws. Shame about your saws. I think you would be best served with Stihl ultra on husqvarna low smoke in the oil departrment. You could probally get yours going again. [/QUOTE]
Insert quotes…
Verification
Post reply
Top