Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
What on earth is happening to blount products
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Little Al" data-source="post: 5877649" data-attributes="member: 42572"><p>No the vertical rear edge of the cutter in the photo ( on the right in the photo ) should be filed so the top outer face is slighty shorter than the lower face an angle of approx 45degs( but parallel to the back edge ) similar to counter sinking the cutter trailing edge in effect shortening the outer surface of the cutter What it is doing in effect is shortening the cutter slightly in overall length as the filed bit is not touching the wood</p></blockquote><p></p>
[QUOTE="Little Al, post: 5877649, member: 42572"] No the vertical rear edge of the cutter in the photo ( on the right in the photo ) should be filed so the top outer face is slighty shorter than the lower face an angle of approx 45degs( but parallel to the back edge ) similar to counter sinking the cutter trailing edge in effect shortening the outer surface of the cutter What it is doing in effect is shortening the cutter slightly in overall length as the filed bit is not touching the wood [/QUOTE]
Insert quotes…
Verification
Post reply
Top