Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Tree Care Forums
Milling & Saw Mills
What size holes to drill in bar?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Mekanizm" data-source="post: 2614858" data-attributes="member: 29884"><p>For a CSM I am going to make that I bolt on to the bar. Maybe two holes near the powerhead and one in the center of the tip.</p><p></p><p>I would imagine it is either for a 5/16" or 3/8" bolt.</p><p></p><p>So what size holes should I put in?</p><p></p><p>Thanks</p></blockquote><p></p>
[QUOTE="Mekanizm, post: 2614858, member: 29884"] For a CSM I am going to make that I bolt on to the bar. Maybe two holes near the powerhead and one in the center of the tip. I would imagine it is either for a 5/16" or 3/8" bolt. So what size holes should I put in? Thanks [/QUOTE]
Insert quotes…
Verification
Post reply
Top