Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Hot Saws
Modded Work Saws
Will a Husqvarna 372XP Cylinder fit a 365?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Marshy" data-source="post: 4661303" data-attributes="member: 120417"><p>Started in with the 280 grit at the exhaust port and quickly switched to the 320 as there just wasn't much there to justify using the course stuff. Didn't really do anywhere else with emry other than finish that area with some 400. I think the scotchbrite will take out everything else, just some small lines here and there. I just have one spot the size of a large pea above the exhaust port that has some scoring. It's noticeable with your finger and it's not transfer. Do I try to buff it out or what?</p><p></p><p>[ATTACH=full]329251[/ATTACH] </p><p></p><p>[ATTACH=full]329252[/ATTACH] </p><p></p><p>[ATTACH=full]329254[/ATTACH]</p></blockquote><p></p>
[QUOTE="Marshy, post: 4661303, member: 120417"] Started in with the 280 grit at the exhaust port and quickly switched to the 320 as there just wasn't much there to justify using the course stuff. Didn't really do anywhere else with emry other than finish that area with some 400. I think the scotchbrite will take out everything else, just some small lines here and there. I just have one spot the size of a large pea above the exhaust port that has some scoring. It's noticeable with your finger and it's not transfer. Do I try to buff it out or what? [ATTACH=full]329251[/ATTACH] [ATTACH=full]329252[/ATTACH] [ATTACH=full]329254[/ATTACH] [/QUOTE]
Insert quotes…
Verification
Post reply
Top