Husqvarna 61 throttle trigger

[stihl041avhog]

What's the best way to replace it. Looks like I need to remove some pins. Never replaced one on a Husky.

 

[HiOctane]

You have to remove the two top shocks to be able to push the pin going to the trigger itself.

 

[stihl041avhog]

do have to take tank/handle off

 

[Gypo Logger]

I never liked playing around with the in handle throttle mechanism. Because I have a lot of part saws I just change out the tank.
Ask Randy or some of the very knowledgable people here.

 

[HiOctane]

do have to take tank/handle off

Yes,to reach top shocks and trigger pin.

 

[stihl041avhog]

Thanks,HiOctane any more tricks to it. It's looks like it's going to be fun.

 

[stihl041avhog]

hg

I never liked playing around with the in handle throttle mechanism. Because I have a lot of part saws I just change out the tank.
Ask Randy or some of the very knowledgable people here.

first time for me and it doesn't look to fun.

 

[stihl041avhog]

Yes,to reach top shocks and trigger pin.

I got the handle off. I now see what your talking about. Does the shocks unscrew or is there a pin that goes thur them. Whats the best way to removed the shocks if I half to?

 

[stihl041avhog]

never mine not to bad if y know where to look

 

[stihl041avhog]

never mine not to bad if y know where to look

I was worried about the spring in the handle but there is not one ,it works off of the carb return spring. The interlock spring might be different! Yes that the whole saw apart and clean it while your there. Wasn't too bad for a old husky