I don't think the 395 is that rich where it's at. I don't think it could go much leaner. I'll check plug color and report back.
Both saws were running a bit rich IMHO.
I don't think the 395 is that rich where it's at. I don't think it could go much leaner. I'll check plug color and report back.
The 660 tached 14200 when we checked it. I don't like to tune to cookie cut. I just like to tune for work and let em roll. I'll check the plug color on the 395.
14,200 is moving pretty good. Maybe they were just loaded up with fuel, as they did seem to clean out OK.
The 660 has a dual port muffler and a little work inside. I don't know for sure as I've not took it apart to see. I don't think the 395 is that rich where it's at. I don't think it could go much leaner. I'll check plug color and report back.
Yeah they were from sitting there idling. That was the first video of the day after they were warmed up and sitting there. The 2171 was idling all the way through that video.
The 660 feels a little smoother. It will change when the mounts wear out. I had another used 660 with worn mounts and it bothered my hands.
The 660 has a dual port muffler and a little work inside. I don't know for sure as I've not took it apart to see. I don't think the 395 is that rich where it's at. I don't think it could go much leaner. I'll check plug color and report back.
The pic itself isn't that good, but from what I can see, the plug is much too dark.
It should look more like this.
Enter your email address to join: