parrisw
Tree Freak
Hey guys been a while. Life is real busy for me these days, haven't done anything with saws in a long while. A friend asked me to look at his saw for him, so thought I'd post it up here, he couldn't figure it out, so this goes to show, keep it simple!! It would idle but not rev, he thought it was the carb and took it apart didn't see anything so put it back together and just made things worse, now it wont run at all. I looked at it, fuel was pouring out of the muffler?? So I thought carb, flooding. Took it apart and saw the diaphragm was not hooked to the needle lever, instead it was holding it open all the time, just pouring fuel through the saw, fixed that, and started it, ran but would not rev, sounded like it has a serious Cold, stuffed up like crazy! So while it was running I unscrewed the muffler deflector popped the screen off, sounds as it should now and runs like it should.
After propane torch treatment.
After propane torch treatment.