Oklahoma,AR,MO,KS,TX GTG (Next GTG 08/27/2016 ) Fort Scott, KS

[67L36Driver]

Yes, best to 'get out of Dodge' then.

 

[Homelite410]

morning my friends!

 

[WKEND LUMBERJAK]

Morning mid lander's.

 

[jerrycmorrow]

Well anyhow the Farmer Tec engine showed up so we put it in the chassis/tank part.
Trip up to the Stihl dealer for fuel and impulse line next. Not taking any risk on those.View attachment 399158

 

[67L36Driver]

Morning all.

Back to wearing my insulated coveralls in the garage. But, the china saw is clean enuff to take in to the kitchen island.

 

[Locust Cutter]

Morning all!!! I've got a feww loops of .063-.325 to sharpen for a neighbor/friend and then it's time to go pick up some Scottish Highland Cattle that the Boss, S.I.L. & B.I.L. and I are buying... It will be nice to be raising our own lean beef. They sure are woolly, docile boogers. Kinda like big dogs with horns. Pics later.

 

[Homelite410]

Anyone have any .063 3/8 semi chisel they wanna get rid if?

 

[Hedgerow]

Morning all!!! I've got a feww loops of .063-.325 to sharpen for a neighbor/friend and then it's time to go pick up some Scottish Highland Cattle that the Boss, S.I.L. & B.I.L. and I are buying... It will be nice to be raising our own lean beef. They sure are woolly, docile boogers. Kinda like big dogs with horns. Pics later.

I hope you got a good deal on them..
The beef quality should be fine, but the carcass Yield won't be quite that of a traditional cross bred beefer..
If I recall correctly though, they do marble. Which is a good thing.

 

[Hedgerow]

Anyone have any .063 3/8 semi chisel they wanna get rid if?

I didn't know you guys ran .063 up there..

 

[67L36Driver]

I didn't know you guys ran .063 up there..

Only on Creamcicles from the pile here.

 

[Locust Cutter]

Sharpening chains listening to CCR and Huey Lewis... I'm good!

 

[Homelite410]

I didn't know you guys ran .063 up there..

My 36" is 63 and I wanna borrow a 36" mill..

 

[Locust Cutter]

So is the 36" Stihl bar I run on the 9010...

 

[Locust Cutter]

 

[mdavlee]

Anyone have any .063 3/8 semi chisel they wanna get rid if?

Ask Nathan. I think he had a partial roll a while back.

 

[Hedgerow]

My 36" is 63 and I wanna borrow a 36" mill..

I have 3 loops of 115dl here in 3/8 .063.
Used of course....
Swing on down and get one!!

 

[67L36Driver]

Sharpening chains listening to CCR and Huey Lewis... I'm good!

John Fogerty for president!

 

[RVALUE]

Anyone have any .063 3/8 semi chisel they wanna get rid if?

I think I have some.

 

[67L36Driver]

Creamcicle question?
How far apart for the legs on the carb. boot clamp?

Don't want to over tighten it.

 

[RVALUE]

I only have 1 - .063 bar, and got two rolls of chain. (25s)

But it probably isn't up to your standards......... It may be european.