How's the 365 rate in the Green/Yellar group ? Ken
They are dern near the same. Just a slightly older version.
Gregg,
How's the 365 rate in the Green/Yellar group ? Ken
088 too?
Wow! That thing ought to kick some ash!
I just love the old Poulans. I ran a 4200 for 28 years. Replacing it is what infected me with CAD.
Are the original P&C that came on your saw usable? If so I would like to buy them if you don't have a use for them. I have a Timbermaster 3600 3.7 ci that I bought that was not quite as represented. Has very low compression. Some day I would like to get it going again.
If I remember right it has the chrome piston aluminum cylinder and very low compression. I didn't know that new chrome cylinder 3.7 top ends were available.
Does that 18 volt Milwaukee impact have enough power to remove clutches? I have one and it is pretty stout compared to my Makita and DeWalt.
View attachment 408131 View attachment 408132
I like those curving quad open transfers, similar to what McCulloch was doing around that time.
It's interesting that the case has notches/cutouts for the entrance to dual open transfers, but the jug does not - the entrance is in the jug and the transfers are short.
Si Senor,Have you still got the 18" .325 bar too?
Here you guys go.......video.
I know where this is going.....325 square.......Have you still got the 18" .325 bar too?
Pocket?I used to play a little pool......
Enter your email address to join: