Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Thank you sir. Gotta start prepping for the baby after I get off work tomorrow
Prepping, that EZ, find the road that's got the most potholes and your set. When she starts to go into labor, finish what you are doing, load up, drive down that pothole road and head to the hospital, should be long and the here is. That way you can go hunting faster.

Steve, Samsung On5 using Tapatalk
 
...but what plug would I remove on the Tilly HL carb? Only one is the main jet and the high/low screw that I remember from working on it.

#25 in the pic.
There is a good chance that your carb may not have one of these.
315107548819dc86a0296d6817da125d.jpg
 
Back a page or two - I don't think the McCulloch 250 ever had the governed HL, all of the I have ever seen were equipped with an HL63. It is possible someone swapped one however...

Mark
Ok, I wasn't completely crazy then. Carb has not been changed on the saw to my knowledge so that still means my needle valve is the culprit.
 

Latest posts

Back
Top