Big Block
WFO or I don't go
Voiding would include a MM, BG delete and timing advance.
261vs3What saw?
Ha no but I was close! I had the muffler off looking at what it would take to do some mods.I am guessing that you probably already have voided it!!
Even after not owning a saw for a while I can still sharpen a chain in my sleep. I’m already running a reasonable fast chain Stihl RS. And it’s always sharp! I had a Echo 590 that would smoke a 555 with the same mods just because of the chain!A good sharp chain is the best upgrade you can make for a saw. Don't be a cheap azz and wear them toothless. A good chain is $15-$20 and saves the whole saw so buy new often and your saw will last longer. Screwing around with a saw in a days work might save you 10 minutes if it is set right air/fuel mix to start with.
Would you like a link to a Magnum sticker.I have Magnumitous.
So you ran a dull chain on the triple nickel so the 590 would beat it .I had a Echo 590 that would smoke a 555 with the same mods just because of the chain!
That’s a good one.......sure why notWould you like a link to a Magnum sticker.
Damn I thought I was the only one that did that!So you ran a dull chain on the triple nickel so the 590 would beat it .
I think most would do it the other way around .That’s a good one.......sure why not
Damn I thought I was the only one that did that!
Restrictive mufflers hold heat. Fix that. Done (for now).You can do that without making an obnoxiously loud machine, btw.
What did you do to the toaster oven, install a micro-controller with a PID loop?@chipper1 to answer your question “why?” Well because I can’t leave anything alone guns,cars,motorcycles,chainsaws.........toaster ovens. I have Magnumitous. If there is performance to be unlocked in something I want it. It’s bad I catch so much **** for it.
I modded the latch mechanism on my microwave because it failed .What did you do to the toaster oven, install a micro-controller with a PID loop?
What did you do to the toaster oven, install a micro-controller with a PID loop?
You had to know this was coming .nuthin yet but it’s on the list. I did however make a billet aluminum and babbet bearing tensioner pulley for my dryer.