stig - I do not know the specifics but I've been told there is belt from a Bridgeport mill that will fit the old Homelite models.
Mark
Mark
What's on your bench
- Thread starter chainsaw _ crazy
- Start date
Help Support Arborist Forum:
Oil pump?
Isn’t that a Flux Capacitor?
Not up there for fixins, just up on the bench sittin pretty 
My 266xp and my buddies 372xp clone
My 266xp and my buddies 372xp clone
Not so much on my bench- as pulled apart- most of it in bits in a box, some bits taken outside for better light.
2002 455 Rancher.
2002 455 Rancher.
The lumberyard in my small town manufacturers a variety of surveyor's stakes from mostly dimensional lumber. Most start with units of 2x3, 2x4, or 2x6 material cut to length.
They cut the units to length with a Stihl 880 equipped with a 60" bar.
They are not very diligent about maintaining their saw.
On this occasion, the clutch bearing was so packed with fine, pine pitch loaded sawdust that the clutch/bearing was virtually locked up. Getting the clutch drum off is not a simple task, but getting the shaft, drum, and bearing cleaned up & lubricated was a simple fix.
Mark
They cut the units to length with a Stihl 880 equipped with a 60" bar.
They are not very diligent about maintaining their saw.
On this occasion, the clutch bearing was so packed with fine, pine pitch loaded sawdust that the clutch/bearing was virtually locked up. Getting the clutch drum off is not a simple task, but getting the shaft, drum, and bearing cleaned up & lubricated was a simple fix.
Mark
Literally just scored this for free..... 20 minutes ago...... It will be a next spring revival if vitals are good. Not a "You Suck" free but free is free!
Just finished.
^^^^^^^^^^
064, getting a new fuel tank, Caber rings, carb rebuild, muffler mod, etc.
Just finished up a full wrap conversion for my 266, I think it turned out super impressive to say the least, feels really good in the hands too, so now I can’t wait to get out and try it In the woods!
Just recently finished the freebie 026. Got rings, hoses, carb kit, tank vent, spark plug, crank seals, double dogs, few other misc bits and pieces. Swapped plastic handle for aluminum one. Opened up the muffler as well. 18” bar with 26RS chain. She cuts!
Where did you get those dogs from? The inner doesn't look stock but I cant remember off the top of my head.
