prosawer24
New Member
hello everyone, so long story short, i've had two ms362c's with mtronic for a good amount of time (around 5-6 years) and both of them have been having probems.
ms 362c mtronic number one, starts up and idles fine, but when you go full throttle the chainsaw just stalls and dies instantly, starts right back up. the carb has been cleaned and fuel lines have been replaced
ms 362c mtronic number two, has two problems, first one. it is not having enough power while cutting ( even when it should have the power),and because of that it loses rpm's and you have to pull out and rerev the saw.
problem number two is that after a few minutes of cutting the saw suddenly stalls, but starts up instantly back up again in a non-ending cycle
if anyone knows why this is happening, would be much appreciated!
ms 362c mtronic number one, starts up and idles fine, but when you go full throttle the chainsaw just stalls and dies instantly, starts right back up. the carb has been cleaned and fuel lines have been replaced
ms 362c mtronic number two, has two problems, first one. it is not having enough power while cutting ( even when it should have the power),and because of that it loses rpm's and you have to pull out and rerev the saw.
problem number two is that after a few minutes of cutting the saw suddenly stalls, but starts up instantly back up again in a non-ending cycle
if anyone knows why this is happening, would be much appreciated!