I really like how clean that you made that saw prior to working on it. Nice job!
my cylinder has divided transfers
That is a 200t cylinder, for sure. Look at the mis-match, which is clearly evident from the gasket marks on your 020t case when previously mated to the 200t cylinder base. The mis-match is obvious from your excellent detail pictures. There is enough 'meat' in the case to allow some port matching here. You don't really have to relieve it all the way, just get a good radius on it so the charge does not run into a flat wall.
Jimbo
thats the plan!
(when I get time to actually work on this for more than 20 minutes!)
Should I raise the partition? Should I thin out and knife edge the partition at the bottom?
Don't knife edge it, just round is good.
raise it any or not?
This is what the inside of the muffler looks like
Enter your email address to join: