Jimmy in NC
Addicted to ArboristSite
Ok.. I know muffler mods are the norm and it seems once you do one or two no biggie. Before I go to cutting/drilling/grinding I have a few questions on the particular muffler on my 026. Do I really need to open this up? I've seen where there were a few different mufflers on this model and some were better than others. I hate to go too big and have performance start to fall off. I also understand this will never be a big saw, I'm just looking for the most out of it I can get, safely.
The victim:
The port:
The outlet:
Thoughts, suggestions?
(Before everyone says that's too much bar for an 026, I know! I use this for a lot of trimming and such and at 6'2" I like it as it's easier to get to the ground with out bending as much and easy to get to the trunk of an ornamental tree to limb.)
The victim:
The port:
The outlet:
Thoughts, suggestions?
(Before everyone says that's too much bar for an 026, I know! I use this for a lot of trimming and such and at 6'2" I like it as it's easier to get to the ground with out bending as much and easy to get to the trunk of an ornamental tree to limb.)