026 Pro Reassembly Order

[Big Neb]

I'm directing this at those of you that can reassemble one of these in your sleep.

What is the most efficient order of reassembly?

I dismantled this saw a few months back and finally have all the pieces and the new donor case. I have the case back together but rather than assemble/disassemble/reassemble... I was wondering what order to put everything back on such as flywheel, electrical, cylinder, carb, tank etc...

I think I just need some rudimentary order...

 

[Dan Forsh]

That's a pretty open question you're asking, but I'll try to answer you.

If you already have the crankcase put back together, and by that I'll assume you have put the crank seals in too, next you should finish the engine by mounting the P&C, flywheel and clutch. after that mount the tank back on the engine, then the ignition unit and carb. If you've disassembled the oiler and chainbrake mechanism set to on them next. Muffler and all the other stuff would be last.