chrisbird
ArboristSite Lurker
Just finished about an hr. of surfing through the forum looking for a similar problem of mine, my 028WB missing out and then dying after about 5 min. of running. Will start up immediately but will miss out and die again. Cleaned the carb, could not get the in tank filter out, fuel line was not long enough to let me pull it out far enough so I sprayed carb cleaner on it and used a tooth brush to reach down in the tank and tried to clean it. Could this be an electrical problem or do you guys think I have a fuel problem? The saw starts within the 2nd pull every time, just after about 5 min. it starts missing out and then quits. After setting for a few min. it will run again but no longer than about 5 min. Appreciate any info I may receive.....