highsiera
ArboristSite Operative
Evvening all, just finished a rebuild on an older 44, and having a bit of trouble.
new seals, gaskets, rings. honed the jug, posiston was fine. even cracked the case to replace the main case gasket.
saw starts and runs in the hot start position, but runs like it's bogging down.Never gets to that sweet wide open throttle sound. clicking the trigger off to the run position kills the saw and sends a spray/ mist of fuel out the carb.
Have messed with the carb settings, swapped carbs, re-adjusted the coil position. no bar/chain etc.. but it's like it's bogging. even removed the sprocket to see it was hanging up on the brake. no luck.
have the muffler cover off, no marks on the piston so I'm doubting the crank is bad.
please help, what am I missing?? I've done a few of these, so I'm no stranger.
Please help. B
new seals, gaskets, rings. honed the jug, posiston was fine. even cracked the case to replace the main case gasket.
saw starts and runs in the hot start position, but runs like it's bogging down.Never gets to that sweet wide open throttle sound. clicking the trigger off to the run position kills the saw and sends a spray/ mist of fuel out the carb.
Have messed with the carb settings, swapped carbs, re-adjusted the coil position. no bar/chain etc.. but it's like it's bogging. even removed the sprocket to see it was hanging up on the brake. no luck.
have the muffler cover off, no marks on the piston so I'm doubting the crank is bad.
please help, what am I missing?? I've done a few of these, so I'm no stranger.
Please help. B