jmssaws
Addicted to ArboristSite
640?What's the flywheel from?
640?What's the flywheel from?
What's the flywheel from?
Yeah brand new still on its first tank of fuel. I know it will be stronger after break in. I think I might wake the 880 up after this. One idea for starters is enlarging the entire muffler. I think the 064 muffler might actually be larger.Is that 880 stock?
I'm curious to know what the performance gains are and if you think it was worth it in the long run. My opinion after owning one was/is the 064 is a beast in original form. Great looking build man. Looking forward to seeing more about this saw.
I've been running the wj35 carb until today when I put the wj69 on it. I'd say the 69 is noticeably better. I was really putting a load on it when recording this.
I'd be a lot happier with myself if I could just get it done before dragging it around. I still haven't put it's own chain on. It's running one way too aggressive for trying to cut under load, and I'm still trying to decide which piston I want to replace this old worn one with. I left the transfers alone because I wanted to see how it ran like that before I get back into it to replace the piston. I'll be raising them accordingly when it comes back apart. That should take care of it letting me slow it down under load like that.Looks pretty sporty.
They can be very strong,doesn't take much.I'd be a lot happier with myself if I could just get it done before dragging it around. I still haven't put it's own chain on. It's running one way too aggressive for trying to cut under load, and I'm still trying to decide which piston I want to replace this old worn one with. I left the transfers alone because I wanted to see how it ran like that before I get back into it to replace the piston. I'll be raising them accordingly when it comes back apart. That should take care of it letting me slow it down under load like that.
I tried a little experiment with the muffler on this thing. I added an extension which I guess can be considered a pipe on it which brings the muffler out about 1 1/4 inches. It seemed to make a pretty good difference in torque.
View attachment 498656
1128 series. I hammered the alignment bumps flat so it would sit flush.What is the deflector you used in the picture originally off of?
Yes I Did.Chainsaw Jim- Did You try any other lengths for the muffler "header tube"?
Enter your email address to join: