Bowtie
Gearhead
I know this has been done before but I made these today.
Safety first!!!!!!!! Round thse sharp points, you could put your eye out!!!I know this has been done before but I made these today.
Safety first!!!!!!!! Round thse sharp points, you could put your eye out!!!
They look really good, nice job.
Stainless or just still shiney?
Rob
. He said "Wow thats a big damn saw for a guy that cuts firewood". :hmm3grin2orange:
He said "Wow thats a big damn saw for a guy that cuts firewood". :hmm3grin2orange:
So, I scored a 361 about 15 minutes after it was listed this morning for a buy it now of $180 including shipping. I tried to order the dual dog kit from my dealer and she said that the part number that I gave her (1135 650 7750) came up as a $3 chain catcher. She is looking into finding the correct kit and going to get back to me, but if I can find a different number it may make her life easier. Anybody got any ideas?
Also, I just wanted to brag about my luck, but that's probably premature until I actually have the saw in my hands. :chainsawguy:
If I had the dawgs to scan (or dimensions, bolt pattern, etc.) I could cut them on our Water-Jet. I could also make any changes you guys think would make them better.
What would you charge to make a set out of stainless for an 044?
Yes, the spikes on a 361 are interchangeable with the 441.
Enter your email address to join: