Found the thread from when I made it. A few pic to give you an idea.
If i can remember the front verticle splitting edge was 3/8 thick. Side splitters are half inch as well as the side plates. The little strap at back to keep it with splitter wedge in ont 1/4 inch x 1 inch flat bar i think.
I started with the side blades on angle and block of wood seemed to make contact with kost of the edge at same time when wood was coming apart from fron blade.
I then switched them to straight across which really never made.much difference on how it split so not a big deel in my opinion.
Ya need a good welder. I did break off a side splitter so took it into work and rewelded with ther big welder with no trouble after that.
Now that i upgraded my welder i may try and make another but a different design then that one for the front of it.
Sent from my SM-G950W using Tapatalk