Hey anyone who’s an expert on 460s. Have plenty of experience building. But I am stumped on this. Rebuilt a 460 bottom up with all oem parts. Saw runs great. The only problem is I can’t get oil to the hole that pushes to the bar. It leaks out or pumps out of the bottom of clutch. I have new oem pump. Oil hose and gaskets. Case was used but in great condition. I’ve blown air through the wholes and tried two different pumps. It’s the third saw I built from bottom up this past winter. Any suggestions would be great. Haven’t even been able to run a tank through it.
Help please kind folks.
Help please kind folks.