Brent Nowell
Addicted to ArboristSite
Wow, every other saw I have can lolIf the saw doesn't have an air leak, just bite the bullet and get a new carb. I think they're a few reputable sellers on eBay that will program the carb to the coil.[emoji111] Don't expect the saw to ever start perfectly when really warm, that's just not going to happen, at least it hasn't in my experience.
So I guess my expectations are too high lol
Sigh... what a pile this thing is turning into.
I appreciate your feedback by the way, I’m just whining.
Brought it to the dealer, the guy who does it wasn’t in... so i ask why no one else can and I’m given this story about how it’s a big technical training session... then they said that I’d have to book it in anyways and wouldn’t get it back same day..
Well now I got mad and said that it takes literally minutes to do, there’s no reason why it has to take more than a day. Also bitched about how I have to pay to update MY saw, I also mentioned that you can’t change any settings, you can only view them. So why is training needed lol?? You plug it in you can upload firmware, or you can look at how the saw is running, that’s it. They just said that only one guy can do it... I bitched some more about this and that and finally they said I should talk to husky and gave me a phone number. So that was that, went home and ripped apart the saw.
Did my first test on the tank vent and looks like it holds a bit of vacuum and pressure.. the pressure I can understand, increase pressure slightly and you prevent gas from leaking out and you increase the boiling point for hot starts. However the fact that it held some vacuum was concerning, probably just enough to cause some starvation issues...
I know there’s an updated part number for the vent, but does anyone have a pic of the new one? I’d like to see if I have it or not
A pic is attached