mp5n
ArboristSite Operative
Has anyone had any experience with the aftermarket (chinese) carbs for the MS200T? I just bought a few of them and I'm not happy with the results. I've tried them on multiple saws, all pressure / vacuum tested fine and with good compression. They are difficult to tune and don't seem to hold the tune between starts. I've swapped out known good Zamas and they run fine. I pulled one apart and nothing seems out of the ordinary. One thing I did notice is that the throttle shaft seems to have excessive clearance.
I go over about 30 of these saws over a year and wanted to try an economical carb. I see them offered by multiple people but I don't know if there are multiple sources from china. If anyone has any experience with them I'd appreciate hearing about it.
Thanks,
MP5N
I go over about 30 of these saws over a year and wanted to try an economical carb. I see them offered by multiple people but I don't know if there are multiple sources from china. If anyone has any experience with them I'd appreciate hearing about it.
Thanks,
MP5N