Antique saw thread

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Don't know what this is but think someone will know? Looks old lolView attachment 438518

I thought it looked like an IEL AB but the logo's were wrong, so,

C.C. ENGINEERING INDUSTRIES LTD.
ecblank.gif
spacer.gif
GUILDFORD, N.S.W. AUSTRALIA

http://www.acresinternet.com/cscc.n...683010cffd2ef764882570f9001844e0?OpenDocument

 
After all the mud dobber nests and crud was removed
The tanks cleaned, it turns over, the rings and cylinder oiled
They are freed up, New plug, put a new fuel lines on it.
I cleaned behind the flywheel it got spark. It fired on prime.....
I am waiting on a carb kit.... in the process of cleaning
The tank this morning fuel got up to the carb, I pulled it over
If fired on its own. I put fuel lines and new filter on
And ran it...... gonna put the kit in , clean it more, and paint
It up. It runs and cuts now..... :)

KINDLE_CAMERA_1438773568000.jpg KINDLE_CAMERA_1438551140000.jpg
 
That was the hard nose off my Lombard
I got from you :) it was on there to check the sprocket
I painted it green and had it on a 610 mac brick for a while
It was ugly.......
 
Ya. I don't want my shirt near that bar
I ordered the decals for that saw last night
Gonna get some paint soon....... it won't be that green you like
Probably red and white :)
 
I got the old Titan Blue streak on monday, took most of it apart yesterday, and it fired up today!... the recoil spring had to get welded (who knows if that will last), but otherwise it looks OK...
I was wondering if any of them have automatic clutches? I can't find any manual clutch on it, just a cam lever to rotate the bar.
 
This recoil spring was broken about 1/3rd of the way out, so i didn't really want to recurve the whole works and end up too short... tried brazing it first but that didn't hold, it snapped at the end of the braze.

I had a hard time keeping the left cylinder firing, kept swapping out plugs and they'd run a bit and die... finally I found the plug wire was grounding out on a fin... will have to put a piece of hose over it or something. I'll work on getting a vid posted up once I have mufflers and a bar on it
 

Latest posts

Back
Top