Wet1
Addicted to ArboristSite
I have a couple of saws that I use fairly often than I frequently run relatively small bars on. Since there is plenty of power on hand, I'd like to get a little more performance (cutting speed) out of them.
The 7900 I just picked up the other day seems to laugh pretty hard at the 20" bar on it, even with an 8 pin installed. Any thoughts on running the rakers down at .040" or lower?
The 7900 I just picked up the other day seems to laugh pretty hard at the 20" bar on it, even with an 8 pin installed. Any thoughts on running the rakers down at .040" or lower?