The GB ArborTech bar pictured at the top is a very nice bar for the A041 mount. Yes there are more expensive bars available but i have had zero issues with this 12" bar on my Dolmar 340. Nice large nose radius and a replaceable sprocket nose all for around $12 USD from Leftcoast. They even have 20" A041 Arbortech bars in 3/8lp for $10 USD!
I also use the GB mincut powertip bars a lot due to the high quality but low cost. The Oregon Pro91 bars are ok too, but for me usually cost way more than the GB ones so i dont buy them very often. I have used them many times and they are a good bar too.
I also use the larger D009 (pictured bottom) for my 365XT, 372XP and 7900 saws. Bars have held up really well. The ones pictured are new obviously and not the ones i have used extensively on these saws!
These Orange bars look fantastic on a Jonsered or Dolmar or Husky saw. Before the paint starts to wear like they all do eventually, they look real nice.
Oh BTW i could not find my 14" techlite bar from my T540, but i grabbed another Oregon Pro91 A095 bar from my 338xpt and i tried it on the Dolmar 340 with the A041 mount. Mount is identical except for the extra oiler hole on the A095 bars. The A041 bars oil through the upper unused tensioner hole. Looking at it closely it did not line up very well to oil through the dedicated oiler hole plus the A095 bars i have dont allow oiling through the tensioner holes. The member who said the techlite top handle bars work for the A041 saws may be mistaken, but without having my techlite is my hands i cannot say. I am 95% sure it won't work. In stock form anyway.