04Bmals
New Member
![AC184792-E665-42BD-8132-54D94255353E.jpeg AC184792-E665-42BD-8132-54D94255353E.jpeg](https://cdn.imagearchive.com/arboristsite/data/attachments/459/459872-b00baf0564de91576de8a479a51c0980.jpg)
![8FD9CEB6-00E2-4E50-88C5-6C5D6C1FC835.jpeg 8FD9CEB6-00E2-4E50-88C5-6C5D6C1FC835.jpeg](https://cdn.imagearchive.com/arboristsite/data/attachments/459/459873-7b9c931d8bfbd07b83e666d46b3c2c98.jpg)
I think I am going too cycle time wouldnt be that much slower. Do you have a recommendation on a cylinder surplus has a bunch with same specs but big difference in priceGo with a 5 inch cylinder.
Is belt slippage a concern?Belt drive
Is belt slippage a concern?
belt drive would not really help anything. The engine can take it, but the bearings in the hydraulic pump are not designed for the side load.
I would use steel plate, and you could look up where the peak torque of that engine is, most likely less than 3600. Adjust the governor to a hundred above that. It will pull like a locomotive, and use less fuel.
Enter your email address to join: