OK, this is a rarity today, an actual serious thread. I know, I know, that's no fun. But I am rebuilding sum saws, and I wanna be sure the cases are clean.
On the first 026 (the one with the cotter pin in the aircleaner), I Q-Tipped as much debris as I could reach, and squirted sum mix down in there and dumped it out, repeating several times. Is there a less smelly/messy, or more effective way to clean out cases before installing the P/C?
No, I dont wanna put it in the dishwasher
I did a search, and I found in "Project 064" sum advice to do just what I've done (thanks Andy), except i didn't turn it upside down. :bang: That saw RLABOH. I don't notice any roughness at all, was careful in disassesmbly, lots of compressed air. I now have a science wash bottle to squirt with. If I hold the case upside down, can I squirt mix onto the bearing itself, or should I avoid that? Also, how many times should I repeat this process, or just until it comes out clear?
Many thanks.
On the first 026 (the one with the cotter pin in the aircleaner), I Q-Tipped as much debris as I could reach, and squirted sum mix down in there and dumped it out, repeating several times. Is there a less smelly/messy, or more effective way to clean out cases before installing the P/C?
No, I dont wanna put it in the dishwasher
I did a search, and I found in "Project 064" sum advice to do just what I've done (thanks Andy), except i didn't turn it upside down. :bang: That saw RLABOH. I don't notice any roughness at all, was careful in disassesmbly, lots of compressed air. I now have a science wash bottle to squirt with. If I hold the case upside down, can I squirt mix onto the bearing itself, or should I avoid that? Also, how many times should I repeat this process, or just until it comes out clear?
Many thanks.