Today - as it was raining outside - I finally changed the handle of my little
one-hand sledge hammer which I use both for wood shopping and for hit-
ting wedges at tree felling ... . As I need this little guy a lot I have ben hes-
itating to change the handle, but today it happened ... .
I suppose that there exist standard diamaters for holes in sledge hammer
heads so that it should be possible to buy premaid handles with fitting
details ... I instead used one of a few scrapped handles I got from a forrest
owner pall - see lower picture (where also the old scrapped handle can be
seen) - then I chopped it at a place where I thought measures would be right
(with a sawed fitting slice (or what it should be called) implemented) - then
I sawed the fitting slice (can be seen in upper picture) - and was happy to see
that it was possible to get the handle into the sledge hammer head with just
the right amount of resistance - then I made an oak wedge from the oak piece
that can be seen in lower picture - and hammered the oak wedge into the
handle - see upper picture - the fitting was concluded by hammering a round
metal wedge (save from the old scrapped handle) into the handle head - see
upper picture - and the result looks surprisingly promising - although it certainly
remains to be established what it is worth ... .
one-hand sledge hammer which I use both for wood shopping and for hit-
ting wedges at tree felling ... . As I need this little guy a lot I have ben hes-
itating to change the handle, but today it happened ... .
I suppose that there exist standard diamaters for holes in sledge hammer
heads so that it should be possible to buy premaid handles with fitting
details ... I instead used one of a few scrapped handles I got from a forrest
owner pall - see lower picture (where also the old scrapped handle can be
seen) - then I chopped it at a place where I thought measures would be right
(with a sawed fitting slice (or what it should be called) implemented) - then
I sawed the fitting slice (can be seen in upper picture) - and was happy to see
that it was possible to get the handle into the sledge hammer head with just
the right amount of resistance - then I made an oak wedge from the oak piece
that can be seen in lower picture - and hammered the oak wedge into the
handle - see upper picture - the fitting was concluded by hammering a round
metal wedge (save from the old scrapped handle) into the handle head - see
upper picture - and the result looks surprisingly promising - although it certainly
remains to be established what it is worth ... .