D&B Mack
Sawin Wit It!
I need to set up three chainsaws to cut 20" SDR11 poly pipe. For those that don't know, 20" is the O.D. and the wall thickness is about 2".
I googled and got some info on how to do it, just wanted to get your opinions as well.
We can't use bar oil. Most companies just don't run any oil. However, I found that paraffin oil can be used. Any experience with this? The fusion company we get certified through said the oil from the plastic is enough, I just don't buy that.
Also, need to keep the plastic "chips" out of the motor. Use mosquito netting?
Any opinions and/or experiences would be appreciated.
I googled and got some info on how to do it, just wanted to get your opinions as well.
We can't use bar oil. Most companies just don't run any oil. However, I found that paraffin oil can be used. Any experience with this? The fusion company we get certified through said the oil from the plastic is enough, I just don't buy that.
Also, need to keep the plastic "chips" out of the motor. Use mosquito netting?
Any opinions and/or experiences would be appreciated.