Echo Model CS-330T
with a full tank of gas the saw seems to run fine when saw is right side up but if you lean it on its side or try cut upside down it runs rough. does the same at idle.
did a clean on the carb (not rebuild) with no result.
I adjusted L screw as far out as I can but when you throttle up it starts to die, so I screwed it in until throttle responds alright. turned up the idle and does not seems to die anymore but rpms fluctuate still when turned/tipped.
any suggestions?
will a carb rebuild fix this?
specifically (just for me and my brain) what causes this?
Thanks
with a full tank of gas the saw seems to run fine when saw is right side up but if you lean it on its side or try cut upside down it runs rough. does the same at idle.
did a clean on the carb (not rebuild) with no result.
I adjusted L screw as far out as I can but when you throttle up it starts to die, so I screwed it in until throttle responds alright. turned up the idle and does not seems to die anymore but rpms fluctuate still when turned/tipped.
any suggestions?
will a carb rebuild fix this?
specifically (just for me and my brain) what causes this?
Thanks